Join our Newsletter

Arrow GL Lever Lock (StoreRoom)

> Door Locks > Commercial Locks > Arrow GL Lever Lock (StoreRoom)

Your Savings:
$116.15 (48.6%)
KA or KD: Information
BackSet: Information

The Arrow GL Series Lever Storeroom Lock is a Grade 1 heavy duty lever lock that offers ADA compliance.  The lever lock features the Arrow "OverDrive" technology that allows the locked lever to rotate freely without retracting the latch. Available in Satin Chrome Finish. Can be Keyed Alike or Keyed Different.


StoreRoom Function Latchbolt operated by key in outside lever or by inside lever. Outside lever always locked.


GL Lever Lock Features:

Housings : Interlocking lever tubes are made from dichromate plated steel. The tubes are attached to the rose insert. This offers fantastic support for a ridged feel without excess movement. Standard bearing sleeves used on most other Arrow lever series are not used on the GL. Requires standard 2-1/8" (53.97mm) bore through door.

OverDrive™: Freewheeling lever action occurs when latch retraction mechanism disengages from lever handle when handle is locked. Built-in stops in the rose insert prevent lever from traveling beyond approximately 70 degrees.

Backset: 2-3/4" (69.85mm) standard.

Door Thickness: 1-3/8" (34.92mm) to 2" (50.8mm).

Latch: Stainless Steel with 1/2" (12.7mm) throw standard. Latch housing is steel, zinc dichromate finish for corrosion resistance. 1" (25.4mm) bore in edge of door is required. Additional latch information below:

Latch front: Stainless steel. 2-1/4" (57.15mm) x 1-1/8" (28.57mm), 1/8" (3.175mm) in 2" (50.8mm).

Strike: Stainless steel. ANSI A115.2, 4-7/8" (123.82mm) x 1-1/4" (31.75mm) curved lip strike standard.

Handing: Non-handed. Levers operate bi-directionally.

Mounting: Thru-bolts within 2-1/8" (53.97 mm) cross bore. Contains two support plates which secure to face of door as well as accept thru–bolts from inside rose assembly.

Exposed Trim: Levers are pressure cast zinc. Streamline rose scalp of brass or bronze complements other series of lever locks.

Rose Inserts: Contain coil spring which is a permanent assembly within rose insert. Inside and outside rose scalps are retained by dimples that create an interference fit with the rose inserts. There are no special retention features added to the rose insert that align the scalp.

Finish: US26D, US3 & 10B

Cylinder: KIK, or SFIC Prep


ADA/Americans with Disabilities Act:
Acceptable Door Hardware: Section 4.13.9

Handles, pulls, latches and other operating devices on accessible doors shall have a shape that is easy to grasp with one hand and does not require grasping, tight pinching or twisting of the wrist to operate. Lever operated mechanisms, push-type mechanisms and “U” shaped handles are acceptable designs.

There are no customer reviews for this product. However, you can be the first person to add a review for this product.

Log in to submit a review
Add Review

(Your browser will be redirected back to this page)